Emax

but if you get a oled display its just desolder old display and solder the new display to the header pins
  ----- Original Message ----- 
  From: Louis van Dompselaar 
  To: emax@yahoogroups.com 
  Sent: Monday, January 30, 2012 6:34 PM
  Subject: Re: [emax] EMAX II Display Problems ....


    
  Check this:
  http://www.dompselaar.org/EMU/EMAX/display.jpg

  That's what I meant. Left is the LED display I was talking about. These are not as thick
  as the old ones used to be. Moreover, they can be made to sit closer to the board
  as the chips on the back are much smaller, which in effect makes it flush with
  the original display.

  I have some of the older LED displays here as well and they are indeed almost twice as thick.

  That leaves only the connector to fiddle about with but it should be doable, at least 
  until I find a source for 16x2 OLED displays. Can't use the EMAX all now as the original
  display is dead.

  Op 30 jan. 2012, om 18:12 heeft jammie het volgende geschreven:

  > led are much thicker beleive me i know as i have replaced over 20 emax displays
  > 

  [Non-text portions of this message have been removed]



  

[Non-text portions of this message have been removed]