Emax

you need a multi meter to see if you are getting the corect voltages you could have cold solder joints

the pads are very small and suffer from thermal overheat when desldering and soldering

looking at your solder joints they are a bit messy 

you need a tester with out one you can diagnose continuity of joints from the connect of the pcb

i always test from the connector of the ribbon cable to the 
lcd panel to make sure that i have continuity and also of testing that the pin 1 is ground as if you have no ground connection then its a open circuit
  ----- Original Message ----- 
  From: freddy1771994 
  To: emax@yahoogroups.com 
  Sent: Saturday, February 11, 2012 9:29 AM
  Subject: [emax] Re: EMAX II Display Problems ....


    
  I simply cannot imagine that I did something wrong... 

  Is there maybe a absoultely last thing I could try/check? 

  Ortherwise I will put my luck in your hands. 
  Thanks
  Freddy



  

[Non-text portions of this message have been removed]