Emax

It is a known detail that some of the Emax 2 floppy drive cables either had
the key in the wrong direction from what is expected or no key at all
allowing for incorrect floppy drive hookup.
Normally on most drives the stripe on the floppy cable is closest to the
power connector and on the Emax (1 or 2) the stripe is always nearest to
the back of the unit.
But some incorrect floppy drive cables (only seen on Emax 2, not Emax 1)
prevented this.

In those cases, I always replace that cable or remove the key, so that it
is "consistent" with the expected configuration.

Regards,
Ted


On Thu, May 16, 2013 at 9:49 AM, Adam <fake@...> wrote:

> **
>
>
> Hello Ted,
>
> i finally could figure out it. in the floppy test section i could change
> jumpers until i got it worked. for this i had to figure out that the
> connector of the head plugged in the wrong direction (it was not keyed).
> flipping it and changing the jumpers made it work.
>
> happy ending!
>
> my other emax ii is not able to read the disk written by this one, but who
> cares....
>
> adam
>
>
> --- In emax@yahoogroups.com, Ted Summers <djtbs1@...> wrote:
> >
> > I don't have an NEC in my stack of drives.
> >
> > Again- if you send me a picture of the jumper sections I might be able
> to piece it together.
> >
> > -T
> >
> > On May 10, 2013, at 12:23 PM, Adam wrote:
> >
> > Hello, i'm trying to fix this floppy drive in the Emax II.
> >
> > Anyone happen to have the same drive working? I'd appreciate having the
> correct jumper settings. (taking a picture maybe?)
> >
> > Or someone who could fix this.
> >
> > Maybe i should get an Amiga to make it work with that, so there's some
> analysing software.
> >
> > The drive looks clean, i doubt it had any mechanical defects.
> >
> > It does format, stepping thru the tracks nicely, and upon finishing,
> says disk error. Will not read a thing. In diagnostics every number stays
> at zero, so it really does not read.
> >
> > It would be a shame to throw out....
> >
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>  
>


[Non-text portions of this message have been removed]