Emax

i had a formerly working mono emax 2 that started that clicking thing where all the lights blink.  i recently purchased a damaged board off someone...poor packing and a few drops enroute it seems....

the mono emaxs two boards are:pc352 rev a 890427
                              pc360 rev a 891107
the broken board has: pc352 rev b
                      pc360 rev c

is it possible to make the mono board stereo from this? any parts that are important to salvage from either board that i dont use?

Sounds like the capacitors in your power supply are bad.  Same thing happened to two of my machines and I just replaced all of the capacitors in the power supplies (one power supply in each machine).  Hope you're handy with a soldering iron.  Not that difficult of a job.  Make sure uF are the same, and voltages should be the same or slightly higher.  Also check the temperature for each capacitor.

Chris


[Non-text portions of this message have been removed]

also check the spade connectors as the solder they used was very week when pulling of cables the spades pull through the solder

  ----- Original Message ----- 
  From: Christopher Christopher 
  To: emax@yahoogroups.com 
  Sent: Sunday, December 11, 2011 2:56 AM
  Subject: [emax] Re: emax boards/repair/rescue....


    
  Sounds like the capacitors in your power supply are bad.  Same thing happened to two of my machines and I just replaced all of the capacitors in the power supplies (one power supply in each machine).  Hope you're handy with a soldering iron.  Not that difficult of a job.  Make sure uF are the same, and voltages should be the same or slightly higher.  Also check the temperature for each capacitor.

  Chris

  [Non-text portions of this message have been removed]



  

[Non-text portions of this message have been removed]