Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor group photo

Yahoo Groups archive

Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

Index last updated: 2026-04-28 23:25 UTC

Message

Re: GSP2101 Problem - Need help

2007-01-31 by Bill Close

That fixed it!  Thank you!!!!  Much cheaper and faster than any of the
alternatives I was considering.

NOW -- Do you guys trade sounds / patches (whatever they are called)
here on the group or do you have a good suggestion for where to get
some new ones.  I can probably recreate most of the lost ones pretty
easily (they were all based on presets and tweaked for various songs
and guitars), but am looking for some new inspiration.  

Bill

--- In gsp-2101@yahoogroups.com, "angelusumbrae" <savage@...> wrote:
>
> Hi,
> 
> I had quite the similar problem a while ago, resetting the unit 
> cured it until now. To reset, do simply the following:
> connect the power cord, press and hold function key 1, switch on the 
> 2101, release function key 1, press the "up"- button.
> 
> Hope that helps,
> 
> Carsten
> 
> --- In gsp-2101@yahoogroups.com, "Bill Close" <billclose@> wrote:
> >
> > Hi,  I found this group after having a problem with my GSP last 
> night.
> > 
> > After booting up I got the usual boot-up screen then saw a screen 
> full
> > of garbage and no sounds.  It's done some different things when 
> I've
> > tried to reboot it like a message that says "Unknown Analog 
> Param". 
> > Any ideas?  It has the 3.00.00.a firmware and the 2nd digital 
> board.
> > 
> > Should I replace the battery?  (It's never been replaced)  Would 
> that
> > make any difference?  Maybe the eproms are bad.  Is there a way to 
> do
> > a full reset when you can't get to any of the menus?
> > 
> > I guess i could just send it to Digitech -- sounds like that would
> > work, but I'm hoping for a quick answer.
> > 
> > Thanks.
> > 
> > Bill
> >
>

Attachments

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.