Hi everyone. I've had my 2101 with the PPC-210 upgrade for almost 13 years now with no problems. That is until last month when I accidently injected a dose of Phantom power to the unit and that called for a visit to Utah for repair (guess I have the phantom power protection upgrade now) Anyway, shortly after the factory returned it, I began having problems with my foot controller just shorting out. I replaced the cable and checked the sockets which seem tightly soldered to the PCB's at both ends. Hardware seems fine. When I try to calibrate the controller I get an error when setting the Min/Max positions. Performed the Factory Reset but still no change. On this 2101 I have left all the factory settings and have not tweaked any of the perameters if that helps. Any ideas what might cause this ? Thank you ! James 2101 w/Artist upgrade Rev 3.00a 20Mhz
Message
Control One died
2008-08-12 by Jey