K5synth

Hi Christian,

In your original 'much easier and (prefer to noise-gain) better' 
modification from the previous post you also state:

"(Or: Replace R33, R34, R35, R36, R37, R38, R39, R40 by 15kOhm-resistors.)"

But now you advise against this? Why is that?
I believe replacing is a more elegant solution than adding additional 
resistors, of course this induces a certain risk of damaging the device, 
but this is something one needs to evaluate for themselves.

Anway, 22kOhm parallel to 39kOhm gives an equivalent resistance of 
14kOhm.. so my question is answered.
Thanks again!

Best regards,
Jeroen Oldenhof


Op 25-2-2016 om 14:04 schreef woerz.herbert@... [k5synth]:
>
> Hello Jeroen
>
>
> Here I repeat for you the NEW (correct) modification once again:
>
>
> The SIMPLEST way to modifiy the output-section of an original K5:
>
>
> Do NOT replace the original resistors!
> But:
> Solder eight 22kOhm-Resistors at THE UNDERSIDE of the print PARALLEL 
> to the following original (39kOhm) resistors:
> R33, R34, R35, R36, R37, R38, R39, R40.
> That`s all.
>
>
> Best regards
> Christian B�ckle
>
>