Korg Mono/Poly

I know its not possible but has anyone made a mod for this? I did try to search the list but didn't hit anything

Paul

Hi Paul

phono1337 schrieb:
> I know its not possible but has anyone made a mod for this? I did try to search the list but didn't hit anything
Have a look at 
http://fa.utfs.org/diy/korg_monopoly/mp_09_klm-356_uP_ArpIn_schemo.gif

On top right side there is IC6 which is a 4051. to its left you will 
find the jack with CV-Out and the connector to KBD-Track. Both are 
connected. Break up this connection, insert a toggle switch which 
connects the KBD-Track either to its original connection, or to the 
point where D1 and R13 are conected together (both are direct above the 
the CV-Out jack in the schematic).

The original position is for the usage with internal CV, the other 
position is for the usage with an external CV.

The KBD-Track split must be done at connector CN20  (top left of the 
KLM356); D1/R13 are located at the top right of the pcb.

No warranty - I did not test this.

Florian

Hi Florian,

I noticed on your website that you are working on a new VCA and VCF board that
would make the Mono/Poly a real polyphonic synth. Have you made any progress with
this modification, or is it currently on hold?

Regards,

Chris

Hi Chris

> I noticed on your website that you are working on a new VCA and VCF board that
> would make the Mono/Poly a real polyphonic synth. Have you made any progress with
> this modification, or is it currently on hold?
Yep. It is on hold. And I am not sure, whether I will continue.

I stopped it in November 2009, as I got a broken Polysix, which I tried 
to resurrect. I wanted to add individual switches for the VCO to the 
Polysix like in the MonoPoly. This way I would have had the same 
arpeggiator tricks with different VCO settings as with the MonoPoly. But 
then again, I had to sell the Polysix again, because I definitely ran 
out of "storage credit" by my girlfriend ;-) (I bought some other gear 
too the last years...).

Now the MonoPoly project has returned to my attention again, but I have 
only a little time for it. I have redesigned the pcbs for the quad 
envelopes (based on SSM2051's from a broken Poly61) in July, but no 
other progress happened since then until now (October).

As said I am not sure, whether I will finish this project, as planned. 
Maybe I will change the quad Envelope to a 3HE compatibel module. I 
bought also a prototype of the Doepfer Quad FilterVcaPanner 
http://www.doepfer.de/a1352.htm / http://www.doepfer.de/A1352.gif. So 
these two might be a good extension for the monopoly too.

Florain