Korg Poly800/EX800 Users

The "Tape" switch and the '3' keypad button are connected to the same
pin on IC34. So, the most likely problem is with IC34.
The patches are held in a 2K static RAM (6116)  that is kept alive
using an onboard CR2032 battery (if present) or by the C cells. So, if
you don't have the onboard backup battery and you don't have C cells
then the patches will disappear every time you turn the unit off.
/Mike
On Tue, 2018-09-25 at 23:42 -0700, zwright88@... [korgpolyex]
wrote:
> Hi all, I have an update and a new question:
> 
> 
> I replaced IC33, and the original issue with my 800 being completely
> unresponsive seems to be fixed! However, new problems have appeared.
> 
> It's currently behaving like it needs the factory patches re-written: 
> the patches are playing low clicks and white noise. However, the tape
> write switch doesn't do anything - flipping it to "enable" doesn't
> make "TAPE" appear like it should, so it's impossible to put it into
> tape write mode.
> 
> Also, the button "3" seems to be unresponsive, as well as a couple of
> the keys. No idea if this is related to the other issues or not.
> 
> Any ideas on where to go fro m here? Would IC34 possibly be a culprit
> or is there something else that may need replacing? I still don't
> think it's an issue with the switch itself as there's no visible
> corrosion and I'd never had that issue in the past.
> 
> Thanks again, this group is an incredible resource!
>