Lpc2000

Hi,
   I tested H-JTAG using wiggler clone and Olimex LPC2106 board.
H-JTAG detected the chip ( ARM7TDMI-S TAP ID CODE 0x4F1F0F0F).
I am unable to debug using ARM STD debugger and keil debugger.
Regards,
      Marcio
--- In lpc2000@yahoogroups.com, "derbaier" <dershu@s...> wrote:
>
> --- In lpc2000@yahoogroups.com, "tsvetanusunov" <tusunov@m...> wrote: 
> > 
> > I found yesterday this web site: http://twentyone.blogchina.com/
> > this guy with nick twentyone works on this RDI support for Wiggler 
> > since year 2004 (the first project was called X-JTAG) and his last 
> > release is made very recently 20/12/2005.
> > I'm going to check if it works with our ARM-JTAG today, if it works 
> > this means our ARM-JTAG (Wiggler) finally will be supported by all 
> > debuggers who have RDI1.51 support, there are instruction how to 
> > config Keil, IAR, STD, ADS to work with his DLL.
> > The best of all is that the source is opened and can be downloaded 
> > freely from this web so support for other hardware can be implemented 
> > easily.
> > 
> > Merry Christmas and Happy New Year to all LPC2000 members!
> > 
> > Tsvetan
> > ---
> > PCB prototypes for $26 at http://run.to/pcb 
> > (http://www.olimex.com/pcb)
> > PCB any volume assembly (http://www.olimex.com/pcb/protoa.html)
> > Development boards for ARM, AVR, PIC, MAXQ2000 and MSP430  
> > (http://www.olimex.com/dev)
> >
> 
> Tsvetan, were you able to get H-JTAG to work in your setup?
> 
> I followed your link and picked up the software to try out with the
> Olimex Wiggler clone that I have. I tried it with two different LPC
> chips and just got it's "Unable to find target" error message.
> Sometimes it was able to reset the target and sometimes it could not.
> It never was able to work with the ARM SDT2.51 debugger.
> 
> -- Dave
>