Lpc2000

Hi, you may try ARM-JTAG (USD19.95) from Olimex. It works well under 
both CrossWorks and IAR.

regards,
Tim Chua
EmbeddedHub.

--- In lpc2000@yahoogroups.com, "Leon Heller" <leon.heller@b...> 
wrote:
>
> ----- Original Message ----- 
> From: "derbaier" <dershu@s...>
> To: <lpc2000@yahoogroups.com>
> Sent: Thursday, January 19, 2006 1:57 PM
> Subject: [lpc2000] Re: IDE choice for peripheral support
> 
> 
> > --- In lpc2000@yahoogroups.com, "dr_danish_ali" <danish@g...> 
wrote:
> >>
> >> Thanks very much Michael and Joel.
> >> This means I ought to download and try out the demo versions of 
IAR
> >> and Crossworks. (Although I can't link them to my hardware 
unless I
> >> buy an appropriate JTAG interface).
> >> I will say in my defence that it was not obvious from the IAR 
website
> >> that the peripherals could be debugged. I did go through the 
flash
> >> demo of the debugger and peripherals were not demonstrated.
> >> Regards,
> >> Danish
> >
> > FWIW, it appears that both Keil and IAR support RDI, and IAR also
> > supoorts Wiggler, so they hardly have "closed" debug interfaces. 
Don't
> > know about Crossworks, since I have not seen a demo version of 
their IDE.
> 
> Crossworks supports the Wiggler, Segger and their own USB JTAG 
interfaces. 
> The latter is good value at 99 GBP.
> 
> Leon
>