Lpc2000

Hello group!

I am working on a design with LPC2114 and I want to use the MULTI
development environment for
the device.
I have connected the JTAG signals and the RTCK to a 20-pins connector,
ref. the ARM 20-pins connector refered to by Green Hills.

There are a few questions I want to put before the group:
- Is correct to force the RTCK signal low via 4.7 ohm resistor to enable
the debug port?

- The DBGSEL signal is described in the LPC2114/2124/2212/2214 manual, but
I can not find it on the LPC2114.
- Can I use the debug/Jtag signal for other purposes when the debug bus is
disabled?

- Does anybody have any experience with the LPC2000 and MULTI environment?

Best regards
Kirsti