Lpc2000

hello,
    thanks steffen for yor reply, i made a loop from CAN1 to CAN2 of the board and i don't ave error, but i still have always an high state on can output.
  ----- Original Message ----- 
  From: Steffen Rose 
  To: lpc2000@yahoogroups.com 
  Sent: Thursday, February 16, 2006 5:47 PM
  Subject: Re: [lpc2000] CAN Problem lpc2129


  Hello,
  On Thursday 16 February 2006 09:57, sketch_1975 wrote:
  > hello, i'm using lpc2129 on MCB2100 vers.3 and keil uVision
  > compiler, i tried lpc_fullcan_sw file and i have a problem:
  > when the trasmission start using buffer 1 i have an error on
  > CANGSR register. somebody can help me??
  > thanks

  I didn't checked this example, but if you write more about the 
  error, we can help you to solve it.

  Note, that you must have more than one CAN devices at the CAN 
  bus. In other case you don't get an ack for your transmission 
  and your CAN Controller go in the state Error passive.

  Regards
  Steffen Rose
  http://www.port.de
  CAN Wiki - http://www.CAN-Wiki.info



  SPONSORED LINKS Microcontrollers  Microprocessor  Intel microprocessors  
        Pic microcontrollers  


------------------------------------------------------------------------------
  YAHOO! GROUPS LINKS 

    a..  Visit your group "lpc2000" on the web.
      
    b..  To unsubscribe from this group, send an email to:
     lpc2000-unsubscribe@yahoogroups.com
      
    c..  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


------------------------------------------------------------------------------



[Non-text portions of this message have been removed]