Lpc2000

Hello,

problem is solved.
It's the philips manual that sucks.
It does not explain in de pin description that p0.14 is used to select
between run mode and isp mode.
Without proper interfacing my controller never got in the run mode,
but stayed in the isp mode.
Problem is solved.

Greatings









--- In lpc2000@yahoogroups.com, "Andrew Berney" <amb@...> wrote:
>
> I assume these pins are set as GPIO then? (We can't see Pinsel here).
> Also, what do you actually mean by 'not running' - it strikes me you
could
> effectively be toggling the pin outputs rather quickly depending on your
> inputs.
> 
> Andy
> 
> -----Original Message-----
> From: lpc2000@yahoogroups.com [mailto:lpc2000@yahoogroups.com]On Behalf
> Of rggmns
> Sent: 11 April 2006 17:29
> To: lpc2000@yahoogroups.com
> Subject: [lpc2000] LPC2103.h file from Keil
> 
> 
> Sorry about de last post.
> It seems Keil has replaced the old LPC2103.h with a new one.
> This last version generates correct addresses.
> 
> The code is not running, included the "very difficult code".
> #include	<lpc2103.h>
> 
> void	main()
> {
> 	unsigned long i;
> 	unsigned long j=0x0000ff00;
> 	IODIR=0x0000ff00;	//set pin direction
> 	while	(1)
> 	{
> 		i=IOPIN & 0x00ff0000 + 1; //delay value
> 
> 		IOCLR=j;                  //toggle I/O pins
> 		j=~j;
> 		IOSET=j;
> 		while	(i!=0)            //time delay
> 		{
> 		i=i-1;
> 		}
> 	}
> }
> It runs fine on the LPC2138.
> 
> What is wrong?
> 
> Me again
> 
> 
> 
> 
> 
> 
> 
> Yahoo! Groups Links
>