Lpc2000

--- In lpc2000@yahoogroups.com, "hodgejackiehank" 
<hodgejackiehank@y...> wrote:
> I want to debug with both serial ports active on an Olimex P1 
target,
> so I am tying to use the RAM loader in Crossworks.
> 
> I have recompiled Loader.EXE but when I try and use it Verify fails,
> probably because I have not configired the build of the Loader 
correctly.
> 
> Does anybody have a ready built one? Program and data are only a few
> K, so I am not fussy where the link splits!

Are you sure that you need to re-compile the loader? The default 
loader uses the ARM's debug comms channel to communicate with the 
debugger and the debug comms channel has nothing to do with the 
serial port. If it is an issue of signal usage, then I can't see that 
the RAM loader would be any better as it uses the same JTAG signals 
used by the debug comms channel loader.

Jon Elliott