Lpc2000

Hi,

Tom is right - the EPI JEENI doesn't support the ARM7TDMI-S core. This
is a part of an email I got from EPI:

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
As you know, the main difference between the ARM7TDMI and ARM7TDMI-S
processors is that the ARM7TDMI-S core incorporates the use of RTCK. 
Unfortunately, the JEENI probe does not have support for RTCK. Adding
support for this is not in the plans, since the JEENI probe has
reached an end-of-development status.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

So I have to use an other JTAG-Probe.

Markus


--- In lpc2000@yahoogroups.com, "lpc2100" <lpc2100@y...> wrote:
> Markus,
> 
> AT91M55800A is based on ARM7TDMI core where as the LPC2106 is based 
> on ARM7TDMI-S core. The debug interface is slightly different. Make 
> sure that you use the ARM7TDMI-S as core type when connecting with 
> jeeni. Also check with EPI if the JEENI RDI driver supports the 
> ARM7TDMI-S core.
> 
> ARM Multi-ICE does auto core detection and can handle most arm
based 
> devices without the need of manual configuration.
> 
> hope this helps
> Tom
> --- In lpc2000@yahoogroups.com, "statler123" <spam77@g...> wrote:
> > Hi,
> > 
> > the problem seems to be the JTAG-Interface JEENI. I just tried
> > debugging the same image with the same settings with the
> > JTAG-Interface ARM Multi-ICE - it worked very well. The same 
> procedure
> > with the JEENI doesn't work.
> > I think - I have to change my JTAG-probe.
> > I used the JEENI for debugging on an ARM AT91M55800A from Atmel -
I
> > hadn't any problems - so I think the combination of the JEENI an
the
> > LPC2106 makes problems.
> > 
> > Markus
> > 
> > 
> > 
> > --- In lpc2000@yahoogroups.com, "statler123" <spam77@g...> wrote:
> > > Hello,
> > > 
> > > I use the ARM ADS 1.2 with the debugger AXD. I would like to
> > download
> > > a small testprogram to RAM and start debugging. As JTAG
> > > debug-interface I use the JEENI from EPI.
> > > I can download the image to RAM correctly. I can see the 
> downloaded
> > > image in the RAM of the LPC2106 at address 0x40000200 and the
PC 
> is
> > > set to the start of the startup code.
> > > 
> > > My problem:
> > > When I start the execution of the programm - for example with a
> > single
> > > step - I get the message "Program terminated normally".
> > > 
> > > Do I have to consider something special like special settings
for
> > the
> > > debugger internals or do I have to load a script at startup of
the
> > > debugger?
> > > 
> > > Thanks,
> > > 
> > > Markus