Lpc2000

Hi Dave,

>> The problem occurs though I'm not touching PINSEL2 or
the Debug port.
The processor seems to go back to some kind of altered
state, since my simple program which blinks an LED on
P2.29 doesn't run, but the bootloader still runs if I
bring P0.14 low.
Normally the bootloader only runs on reset, and
bringin P0.14 low after that won't re-start the
bootloader. <<

I have my head inside a DSP at the moment, so I may be wrong, but I would 
suggest you double check those PINSEL registers just to be absolutely sure. 
If I wasn't struggling with interrupts on this damn DSP, I might realise I 
was talking b*llocks! ;-) 

I had no end of problems with these pins and registers! Good luck. :-)

Cheers,

Rob