Lpc2000

Hi Daniela,

A few weeks ago, I tried to evaluate the CAN Interface without the 
demo files, only with Philips User Manual, and it ended in a big 
chaos.

For this Sort of Controllers, you need a little bit source code from 
the manufacturers of the controller or the compiler. If possible, use 
the FullCAN Example from the Keil Homepage:

The File is called "LPC2_CAN_EXAMPLES.ZIP".

You can download it from the following link:

http://www.keil.com/download/docs/lpc2_can_examples.zip.asp

The unzipped Folder is called "LPC2_CANFull_V110".

It's not only an Example, but very professionell, one may initialise 
1 to 4 CAN Interfaces by #ifdef-#endif compiler steering dependant to 
the used LPC2000 Controller part (2129, 2294, eg.). The Example uses 
the right PINSEL selections for each of the selected CAN Controller.

Your Pin Selection for CAN Controller 2 is right, the same as in the 
FullCAN Example.

What Code and ARM Board do you use? The Keil MCB2100 or other???

I have modified the FullCAN Example to fit it to my Application, 
added a Standard Group Acceptance Filter Initialisation and Auto-Bit-
Rate-Detection described in the Philips Application Note AN97076, 
Page57, for the Philips SJA1000 CAN-Controller. That all costs a few 
days of development but works very well on my Keil MCB2100 Board.

My Keil MCB2100 works together with a CAN Analyzer on the CAN 
Controller 1 and 2 (CANalyzer from "vector informatik"), such a tool 
for your PC is very useful and helpful and certainly necessary to 
make decisions on bus traffic, identifiers, acceptance filters and 
statistics.

Greetings from Dietmar.

www.weiss-electronic.de


--------------------------------------------------------------

--- In lpc2000@yahoogroups.com, "daniela_boyo" <dob3@l...> wrote:
> 
> Hi everyone,
> 
> I'm having some problems using the 2nd CAN controller network on 
the 
> LPC2129 ARM board. So far I have successfully used the 1st CAN 
> controller and I'm now trying to incoorporate the 2nd one. I'm 
using 
> the same code as the 1st one except that I have changed the PINSEL1 
> register as follows:
> 
> // Enable pins for selected CAN port 2
>    PINSEL1 |= 0x00014000L; // Set bits 14 and 16
> 
> and all the CAN registers from 1 to 2.
> 
> Is there anything else that I am missing out that needs to be done 
in 
> software?
> 
> Any help would be greatly appreciated.
> 
> Thank you!
> Daniela.