Lpc2000

Leon,
 
From your website, I see that pins 3,17,19,11 are not connected at target
end (20-pin)
On the development board of MPC2130 of Keil pins 17, 19, 11 are connected to
ground through 10K resistor
and Pin 3  has a 10k pull-up resistor.
 
Does these changes matter to talk to the target.
 
Thanks,
Ken

-----Original Message-----
From: Leon Heller [mailto:leon.heller@...]
Sent: Tuesday, 22 February 2005 6:50 PM
To: lpc2000@yahoogroups.com
Subject: Re: [lpc2000] software for connecting to target with wiggler
interface


----- Original Message ----- 
From: "Raj, GS" <gsraj@...>
To: <lpc2000@yahoogroups.com>; <kenbnny@...>
Sent: Tuesday, February 22, 2005 7:41 AM
Subject: RE: [lpc2000] software for connecting to target with wiggler 
interface


>
> Leon,
>
> Is it latest OCD commander software or older version you have used.

My interface works with the latest software. The schematic and PCB in 
jtag.zip were updated with the connection between pins 8 and 15 on the 
DB-25.

Leon 



-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 266.1.0 - Release Date: 18/02/2005



  _____  

Yahoo! Groups Links


*	To visit your group on the web, go to:
http://groups.yahoo.com/group/lpc2000/
<http://groups.yahoo.com/group/lpc2000/> 
  

*	To unsubscribe from this group, send an email to:
lpc2000-unsubscribe@yahoogroups.com
<mailto:lpc2000-unsubscribe@yahoogroups.com?subject=Unsubscribe> 
  

*	Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
<http://docs.yahoo.com/info/terms/> . 



  _____  

Message protected by MailGuard: e-mail anti-virus, anti-spam and content
filtering.
http://www.mailguard.com.au/mg <http://www.mailguard.com.au/mg>