Lpc2000

Hi

Programming the LPC210x at 60MHz didn't cause a problem - it seems 
to work fine.

We did make a mistake in passing the PCLK (1/4 in this case) instead 
of the CLOCK as parameter (in kHz). The effect was that the FLASH 
was not programmed long enough and so the data was not reliable. 
Typically the board would work fine after power up but after a reset 
it wouldn't start because a check sum run across the program code 
would signal an error.

After this silly mistake all has been stable.

Regards

Mark Butcher

www.mjbc.ch

> So, it just proof the old classic, never trust a Philips 
Datasheet !
> 
> /Jesper