Lpc2000

Hi

I'm using LPC2194
I have problem getting interrupt in CAN bus. Here is the parts of my 
code that has some problem don't know what.
The Bus should be configured to 1 Mb. If someone could give me a tip 
whats wrong I would be glad.

/////////////////////////
// PLL setup values are computed within the LPC include file
// It relies upon the following defines
#define FOSC                (10000000)        // Master Oscillator Freq.
#define PLL_MUL                (1)                // PLL Multiplier

// Pheripheral Bus Speed Divider
#define PBSD                1                // MUST BE 1, 2, or 4
#define PCLK                (CCLK / PBSD)    // Pheripheal Bus Clock Freq.
///////////////////////

// Interrupt Service Routines
void CAN1IRQ (void) __attribute__ ((interrupt));

//////////////////////
void CAN1IRQ (void){
        blink();
C1CMR = 0x00000004;         // Release the receive buffer
VICVectAddr = 0xFFFFFFFFL;     // Acknowledge interrupt
}

////////////////////
can1InitRx(){
PINSEL1 |= 0x00040000;         // Enable Pin 0.25 as CAN1 RX
AFMR = 0x00000002L;            // Switch off the acceptance filters
C1MOD = 0x00000001;         // Set CAN controller into reset
C1GSR = 0x00000000;            // Clear Status Register
C1BTR = 0x430005;         // 1MHz CAN bus rate
VICVectAddr0 = (unsigned int)CAN1IRQ; // Set And Enable receive interrupt
VICVectCntl0 = 0x0000003A;             // select a priority slot for a 
given interrupt p92 3a=26
VICIntEnable = 0x04000000L;         // CAN1 Rx enable interrupt
C1IER = 0x00000001;         //Enable the Receive interrupt
C1MOD = 0x00000000;         //Release CAN controller
}

//Artturi