Lpc2000

I have a similar interest.  I'd like to use both uarts and
at least 2 PWM outputs that are 2 channels away from
each other (for 2 phase 180 degree out of phase pwm
drive).  I believe that I am  able to
use pwm 3 and 5 (or was it 1 and 5?) or something like that.
I hear the words "I/O map" being used around the LPC
circles but that may be just for setting pins for I or O or the 
special dedicated functions assigned to those pins.  I haven't gotten 
that far yet.

bob


--- In lpc2000@yahoogroups.com, amastella@v... wrote:
> Hi, I'm studying LPC2214 for use on a new project. I have some 
doubts and I think someone could help me in this forum.
>  
> 1) I need to control 3 step motors. They are completely 
independent. In the Philips LPC User Manual, they say it's better use 
channels 2, 4 and 6 for double edge. It's not clear to me how can I 
make one motor accelerate while another one is in it maximum speed i. 
e. how can I maintain their independency.
>  
> 2) If I use PWM channels 2, 4 and 6 I can't use UART1(PWM6 and 
UART1 use the same pin)... Is that correct?
>  
>  
> Thanks
>  
> Andre
> 
> [Non-text portions of this message have been removed]