Lpc2000

Hi Bill.
 
If you're not using the extra I2C interface, you should be able to use
the LPC2124 user's manual.  I had a board design based on the LPC2124
and laid the board out so I can swap it for the LPC2138 when it became
available.  Last week I replaced the LPC2124 with the LPC2136.  I used
the same flash program file for the LPC2124 on the LPC2136 and it worked
without a problem.  I did not have to recompile the software for it to
work with the LPC2136.  If there gotchas, I haven't run into them...
...yet.  
 
Ron
 
 
________________________________

From: lpc2000@yahoogroups.com [mailto:lpc2000@yahoogroups.com] On Behalf
Of tonalbuilder2002
Sent: Tuesday, June 28, 2005 9:56 PM
To: lpc2000@yahoogroups.com
Subject: [lpc2000] Elvis Sightings and the Elusive LPC2138 User Manual
 
After much digging I found a November, 2004 prelimary LPC2138 User 
Manual posted here in the Files section.  It looks like it's 
just the same old set of Arm peripherals.  But I'm starting on a
LPC2138 board design and am feeling a little nervous about 
any LPC2138-specific "gotcha's" that might make the 2138 a tad 
different than other LPC2's, and cost me another board revision.

So...

1. Is there a later LPC2138 manual tucked away somewhere on Web?
2. Has anybody been bitten by a LPC2138-specific oddity that sets it 
apart from other LPC2's, especially in the UART and SPI peripherals?

Thanks!

Bill T.
http://www.kupercontrols.com



________________________________



[Non-text portions of this message have been removed]