Lpc2000

Hi,

I would like to port my sed1335 driver to the lpc. I would like to use
it in memory mapped mode, so I connect data, rw, e, and cs lines. I
have an A0 pin on the lcd, which state is depends on that I want to
send data, or command.I plan to connect A0 to the address 0 of the
lpc, and than if i'm write to address 83000000 a0 will be 0, write to
83000001 A0 will be 1. (8bit bus) Will this work? :) I know I need to
set PINSEL2, BCFG3, but what about the delays. SED1335 is not a fast
device.

Any comments?

Thanks and Regards,
Andrew