Lpc2000

Hi,
The all pins seam to float or be as input even after I configure the 
PINSEL1 register. I'm using a LPC2214 as
the master and the 25Lc640 as a slave. I've connected the SSEL to 3 volt.
Regarding the setup of the registers I've tried the IAR MakeApp code for 
the PCB module and the SPI module. And at the
moment this gives the same result.

Regards Jens Alsig


y4krys wrote:

> --- In lpc2000@yahoogroups.com, "jensalsig" <alsig@g...> wrote:
> > Hi,
> >
> > have anyone every used the SPI 1 channel on a LPC device that has 2
> > channels?
> >
> > I've tried without any luck and getting very frustrated! I have tried
> > using the IAR MakeApp and that doesn't work either. My setup is a
> > LPC2214 from Olimex and a MicroChip EEPROM.
> >
> > Any suggestions are VERY welcome.
> >
> > Regards Jens Alsig
>
> Hi Alsig,
> What do you mean by "doesn't work"?  Is SPI1 properly setup (IO pin
> selection and function, Master/Slave etc.) and enabled?  Have you
> checked the bus with a scope?  What hardware do you use?
>
> Krys
>
>
>
> ------------------------------------------------------------------------
> YAHOO! GROUPS LINKS
>
>     *  Visit your group "lpc2000
>       <http://groups.yahoo.com/group/lpc2000>" on the web.
>        
>     *  To unsubscribe from this group, send an email to:
>        lpc2000-unsubscribe@yahoogroups.com
>       <mailto:lpc2000-unsubscribe@yahoogroups.com?subject=Unsubscribe>
>        
>     *  Your use of Yahoo! Groups is subject to the Yahoo! Terms of
>       Service <http://docs.yahoo.com/info/terms/>.
>
>
> ------------------------------------------------------------------------
>



[Non-text portions of this message have been removed]