Lpc2000

Arie de Muynck wrote:

> > I've got an overview of what I'm thinking of going with for the
> > evaluation card.  < http://tinymicros.com/embedded/LPC210x >
>
> 1.
> In the block diagram it says "Off-board connectors are 2.5mm".
> I hope you mean 0.1", that is 2.54 mm, so one might use standard flatcable
> connectors?
>
No, the 2.5mm is correct.  If you'll notice, that applies to the coaxial 
power connector.  2.1mm and 2.5mm are the two standard center pins 
sizes.  All 2x? headers are on .1 inch centers. 

> 2.
> Xtal=14.74 MHZ is easier obtainable and gives better baudrates?

Yes.  I didn't have the exact frequency on hand last night.  I plan to 
socket the crystal, and the clearances are for a standard HC-49 sized 
footprint.  I may put a set of SMT pads down adjactent to it.

>
>
> Regards,
> Arie de Muynck
>