Lpc2000

Is it required to cycle power on the MCB2130 board after flashing with 
the Philips flash utility and before a second flash attempt. It always 
seems to work the first time, but not the second without removing 
power first. I don't understand why because pin P0.14 is being pulled 
low correctly by DTR and P0.14 is pulled low correctly by RTS. Any 
thoughts?

Thanks-
Tim

--- In lpc2000@yahoogroups.com, "tah2k" <tah2k@y...> wrote:
> Is it required to cycle power on the MCB2130 board after flashing with 
> the Philips flash utility and before a second flash attempt. It always 
> seems to work the first time, but not the second without removing 
> power first. I don't understand why because pin P0.14 is being pulled 
> low correctly by DTR and P0.14 is pulled low correctly by RTS. Any 
> thoughts?
> 
> Thanks-
> Tim

If you use the JTAG after flashing then you have to cycle the power -
at least that's what I've been experiencing.
If I don't use the JTAG then I have no problems with flashing several
times, without cycling the power.

Best Regards
Søren