MOTM

I just wanted to throw my $00.02 in here about drilling.� If you are getting ready to drill your Stooge panels (or any panel really), and you just so happen to have access to a machine shop equipped with a milling machine, use that instead of the drill press.� I found that a milling machine will make�a nice, perfectly round, clean hole with�almost no flash on the back side.� Also, they are usually more�precise than�most drill presses, and I have not yet needed to use a�center punch.� Another benefit is that the flash from the hole generally travels up the bit, away from what you are drilling, so you don't risk scratching your beautiful panel finish.� I'm not knocking drill presses, just if you happen to have a choice between the two, use the milling machine!� If you don't, then listen to Larry Hendry.

Kevin