MOTM

Damn! I wish I ordered that cool looking Pomona grabber lead -- I already 
ordered one that has individual leads.

Anyway...

So you can power about 19-20 modules total? As long as there are:

1)  no more than 11 of the 4 pin modules

AND

2)  no more than 8 of the 6 pin modules

I didn't see any problems with the manual, but it was a bit difficult to 
follow without a 950 kit to check against it.

Note: the two sections I quote from below are close but not in complete 
agreement about the number of modules which can be powered. (I say split the 
difference and say no more than 7 of the 6 pin and no more than 11 of the four pin. 
Stay lucky -- 7 * 11)


From the top of page 3.
------------------------------------------------------------------------------

The supply can power approximately 11 4-pin modules and 8 6-pin
modules. An expansion connector board, the MOTM-990, is available for 
attaching
additional modules.




The last paragraph of page 12.
------------------------------------------------------------------------------
------------
This power supply can power BOTH 4-pin modules AND newer 500/600 Series 
modules
at the same time. Just remember, the MOTM-950 can ONLY power about 12 4-pin
modules maximum. It can power 6 to 8 500/600 Series 6-pin modules as well.