MOTM

On 4/22/04, Brice D. Hornback put forth:
>I would *highly* recommend against putting any signal into the TTL serial
>input pin that isn't a serial interface from either a PC or microcontroller
>that is actually sending *correct* communication to the chip.  Reason
>being... you will most likely really mess up your chip.  Just don't do it.
>
>The other input pins you referred to can be programmed for sounds and
>triggered to play on both a high AND low signals.  To get *true* analog
>Voltage Control over the SpeakJet requires something like... say... well,
>the only module in existence that will do it... the SynthModules PSIM-1.
>:-)

I'll take the ":-)" under consideration -- if it can be controlled 
via CV, it can be controlled via CV :)   I don't have a PS1M-1, or 
have any plans to buy one, because I would not use a PC as a studio 
computer.  My question regarding the SpeakJet, is it possible to set 
it up and use it without using a PC??