MOTM

Exactly the procedure I use with resistors.  I place them all, crimping 
the leads by bending them toward each other using my fingers.  I always 
cut the leads before soldering, so that the solder flow is not disturbed 
by cutting the lead.

-Richard Brewster

Jeff Laity wrote:

>I have a little tip for first time kit builders. Instead of soldering 
>resistors one at a time, place them all first. I would go to a step, 
>find the resistor value, measure each one to make sure I had the 
>correct value, then put them in the board. Once all of the resistors 
>were placed, I would solder them all. This way, if I happened to put a 
>part in the wrong hole, I wouldn't have to de-solder it to change it 
>out. I would get the the next step, say "oh, there's already a part in 
>R17," and then put them in their proper places. (I think this might 
>have happened one time.) I did this for the capacitors and other 
>related parts as well when possible.
>
>  
>