Synth-DIY Yahoo! Groups Archives

RE: [motm] FW: MOTM-820 VC Lag PCB ISSUE

2000-04-27 by Brousseau, Paul E (Paul)

Did the original message from below go out to the list?  

--PBr

Show quoted textHide quoted text

> -----Original Message-----
> From:	Dave Bradley [SMTP:daveb@...]
> Sent:	Thursday, April 27, 2000 10:44 AM
> To:	MOTM List
> Subject:	[motm] FW: **MOTM-820 VC Lag PCB ISSUE**
> 
> 
> > This is easily accomplished by "blobbing" solder (the no-clean
> > type) on the
> > 2 pins of the IC.
> > [For some of you, this will come naturally].
> >
> 
> Another way is to cut a very short length of scrap resistor lead, just
> long
> enough to bridge the two pins - mechanically, it's sounder.
> 
> If you're taking orders already, I'll take one (kit)! When is the
> projected
> shipping date?
>

RE: [motm] FW: MOTM-820 VC Lag PCB ISSUE

2000-04-27 by Dave Bradley

No, it went out to Paul's "Synthtech" mail group, which is I assume a list
of registered MOTM owners, which is not the same thing as members of this
list.

If you are an owner but didn't get the original message, maybe his list
needs to be updated. I'd repost it but I already blew it away.

Basically it says that there is a boo boo on the new MOTM-820 pcb, that can
be easily fixed. Two adjacent pins on one of the ics need to be connected
together, with a solder blob or a tiny length of wire.

Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@...

Show quoted textHide quoted text

> -----Original Message-----
> From: Brousseau, Paul E (Paul) [mailto:noise@...]
> Sent: Thursday, April 27, 2000 1:35 PM
> To: 'motm@egroups.com'
> Subject: RE: [motm] FW: **MOTM-820 VC Lag PCB ISSUE**
>
>
> Did the original message from below go out to the list?
>
> --PBr
>
> > -----Original Message-----
> > From:	Dave Bradley [SMTP:daveb@...]
> > Sent:	Thursday, April 27, 2000 10:44 AM
> > To:	MOTM List
> > Subject:	[motm] FW: **MOTM-820 VC Lag PCB ISSUE**
> >
> >
> > > This is easily accomplished by "blobbing" solder (the no-clean
> > > type) on the
> > > 2 pins of the IC.
> > > [For some of you, this will come naturally].
> > >
> >
> > Another way is to cut a very short length of scrap resistor lead, just
> > long
> > enough to bridge the two pins - mechanically, it's sounder.
> >
> > If you're taking orders already, I'll take one (kit)! When is the
> > projected
> > shipping date?
> >
>
> ------------------------------------------------------------------------
> You set the price on thousands of products. Computers, electronics,
> art, home appliances and more.  Visit uBid today!
> http://click.egroups.com/1/3026/3/_/529958/_/956864988/
> ------------------------------------------------------------------------
>
>