The Mellotron Group

Hi again Ben-

    Looks like you already had the "rounding" dialed in on those outer ribs, my mistake.  Height was the only issue.

   -Bruce

    
--------------------------------------------
On Fri, 7/28/17, Bruce Daily pocotron@yahoo.com [newmellotrongroup] <newmellotrongroup@yahoogroups.com> wrote:

 Subject: Re: [newmellotrongroup] 3d printed M400 power cap
 To: newmellotrongroup@yahoogroups.com
 Date: Friday, July 28, 2017, 10:49 AM
  
       
       Hi Ben-
 
     Your draft looks pretty darn good!  I agree with
 David, the outer ribs run all the way from the bottom flange
 to just below the top edge.  The sides & tops of the
 ribs are rounded, if possible.
  
     The crack I noticed was isolated to the middle of the
 cover body, across the area where the tension ring locates,
 and may have been there already.  Thanks for the offer of a
 cap, though!
 
 The description of the cap Mr. Leete describes would be a
 "bayonet" mount (similar to BNC connectors and
 many automotive light applications).  This makes me wonder
 if there were production variations in the switch/cap combo,
 and might be worth researching.
 
 It is amazing your printer is capable of reproducing
 something this small with accuracy.  I look forward to the
 results.
 
 -Bruce Daily
 
      #1221
 --------------------------------------------
 
 On Fri, 7/28/17, David Ub ultraboreal@gmail.com
 [newmellotrongroup]
 <newmellotrongroup@yahoogroups.com> wrote: 
 
 Subject: Re: [newmellotrongroup] 3d printed M400 power
 cap
 
  To: newmellotrongroup@yahoogroups.com
 
  Date: Friday, July 28, 2017, 2:33 AM
        
 
        Please read "less than 1mm from top
 
  of the cap", just to be clear!