Discussion about the Korg PolySix synthesizer

thanks! i'll give it a try this week.
- roy

--- trekpilot <trekpilot@yahoo.com> wrote:
> Hi Roy.
> 
> Modifying the effects board for an external IN is
> very simple.  All I
> used is a SPDT toggle switch, a mono jack, and a tap
> to the effects
> signal in line.  I simply wired the external jack
> tip (signal) line
> into one side of the switch.  The other side of the
> switch is the
> synth signal line (for normal operation.)  The
> center pole leads to
> the Signal IN line of the effects board (yel/wht
> cn-14).  This allows
> you to switch between the synth voices and your
> external signal. 
> Don't forget to ground the jack ring connection...I
> simply connected
> it to the other jack grounds.
> 
> There are two additional steps: 1) solder a 100ohm
> resistor between
> the external signal jack and the switch lead to
> decrease the signal
> level.  Also, it is up to you where you want to
> mount the switch and
> the jack.
> On my setup, I send the signals from my AX80 into
> the Polysix effects
> board.   Haven't tried it with recorded audio or
> other signals, but
> this should work for you.  
> 
>                          O-------------- Synth
> signal 
> To FX signal in--------O
> (KLM-386A CN14 pin 1)    O-----/\/\/\--- External
> signal (jack tip)
>                                100ohm 
> 
> Hope I've helped, and have fun with the toys!  Let
> me know if you have
> any other questions I can help you with.     


__________________________________
Do you Yahoo!?
The New Yahoo! Shopping - with improved product search
http://shopping.yahoo.com