Synth-DIY Yahoo! Groups Archives

Part code - EG intensity Pot

2013-09-24 by <rufushaw@yahoo.it>

Hi all there, I'm writing from Italy.

I'm looking for a part code number for a spare.

I'm refurbishing a P6 in poor conditions due to several hits over the chassis froma very hard duty use.

I've restored the whole synth and only one step is missing.

The P6 owner blasted the "EG intensitiy" pot which is different from others.

It has a lock on the center of the span, and it has a 4 pins footprint.

As far as i can read is a 10KOhm C23.

Help much appreciated.

Thanks,

Re: [PolySix] Part code - EG intensity Pot

2013-09-24 by klosmon

That's a 10K ohm center-tapped pot;  in addition to the terminals at 
each end of the resistance strip, there's also one in the center.  This 
kind of pot (also used on things like the EML synths) is extremely hard 
to find new;  your best bet is to find someone who's parting out an old 
Polysix & get one from them.

~G

Show quoted textHide quoted text

On 9/24/2013 6:09 AM, rufushaw@yahoo.it wrote:
>
> Hi all there, I'm writing from Italy.
>
>
> I'm looking for a part code number for a spare.
>
> I'm refurbishing a P6 in poor conditions due to several hits over the 
> chassis froma very hard duty use.
> I've restored the whole synth and only one step is missing.
>
> The P6 owner blasted the "EG intensitiy" pot which is different from 
> others.
>
> It has a lock on the center of the span, and it has a 4 pins footprint.
>
> As far as i can read is a 10KOhm C23.
>
> Help much appreciated.
> Thanks,
>
>

Discussion about the Korg PolySix synthesizer

Part code - EG intensity Pot

Part code - EG intensity Pot

Re: [PolySix] Part code - EG intensity Pot

Move to quarantaine