Synth-diy-test

What did you use for a programmer!? That's a pretty unique (oddball) 
part: 512 *bytes*.  No matter what parallel chip you use, it's going to 
require an adapter of some sort.  2732 looks closest, assuming your 
programmer can handle it. Otherwise I guess it doesn't really matter. 
How are the control lines E1*, E2*, S* attached? One for chip select and 
the other two grounded (or perhaps one to an address line)?

GB

On 1/27/2026 8:39 AM, Raf Wlodarczyk wrote:
> The digiky ones come from Rochester and ALL the ones (i bought 50 of each type) I got from them were bad, partial writes, wouldnt clear etc.  I'll look at the AT27, thanks for the suggestion
>
>> On 01/27/2026 11:26 AM EST Roman Sowa <modular@go2.pl> wrote:
>>
>>   
>> DigiKey has a thousand of them, but anyway, I wouldn't buy them because
>> of the price and age.
>> Whenever I need to replace old EPROM I pick most common, cheapest and
>> easy to get OTP EPROM, which usually is AT27C256. It has 28 pins so 4 of
>> them will be outside of the socket, which typically can fit on the old
>> board without pushing other components. After programming just wire 5
>> pins together: 1,2,26,27,28
>>
>> Or you may fance making breakout board for PLCC EPROM
>>
>> forget about buying newly made EPROM smaller than 256kb
>>
>> Roman
>>
>> W dniu 2026-01-27 o 16:16, Raf Wlodarczyk pisze:
>>> Hello list,
>>>
>>> The supply of the IM6654 PROM i use in my Spider clone has dried up and was wondering if anyone had suggestions on how to use a modern part for a replacement.  IM6654 is a 8x512B device so could using a AT28C512 on an adapter do the trick?  My PROM/EEPROM knowledge is limited so any help would be greatly appreciated.
>>>
>>> -R
>>> ________________________________________________________
>>> This is the Synth-diy mailing list
>>> Submit email to: Synth-diy@synth-diy.org
>>> View archive at: https://synth-diy.org/pipermail/synth-diy/
>>> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
>>> Selling or trading? Use marketplace@synth-diy.org
> ________________________________________________________
> This is the Synth-diy mailing list
> Submit email to: Synth-diy@synth-diy.org
> View archive at: https://synth-diy.org/pipermail/synth-diy/
> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace@synth-diy.org