Vintage Synth Repair

----- Original Message -----

From: paintingwithsound

To: vintagesynthrepair@yahoogroups.com

Sent: Tuesday, October 07, 2008 12:56 AM

Subject: [vintagesynthrepair] Re: First message/some CS80 questions

You can look at the FET as a switch. It appears to be turned on very
briefly by the key gate into a decaying sample and hold which should
give a very fast rise to the AT level followed by a decay set by the
10M resistor & cap.

As far as the two different resistors goes they are probably balancing
the two filters and if you look at the resistors labled R6 & R7 with
no value they are probably for fine calibration.

--- In vintagesynthrepair@yahoogroups.com, "maxferfranc"
.> wrote:
>
> Hi all, this is my first message here: I'm thrilled by analog circuits
> although I'm not an expert, so I'm studying the Yamaha CS80 to try and
> make some sort of virtual, as I'm not satisfied with the Arturia.
>
> I would ask you some questions to the people here who knows more than
> me about reading schematics
>
>; First question: if you look at the picture I posted there
>
> http://f1.grp.yahoofs.com/v1/YIrqSApHmjS6cA3dqhZH-
> GmV76P2YcikZA_XszBHjYyz7poNC3SZztKSOwD4kC4LWbNppnry_1movZzpGN2mUqumJOKHG
> p_Ipg/CS80%20schems/tws.jpg
>
> You will see the velocity generator in Yamaha CS80: I'd like to know
> this: what is the FET doing here? And, what is the output of
> the "Initial touch"? Is it a decay envelope? How does it link to a
> supposed variable gate velocity?
>
> Now look here
>
> http://f1.grp.yahoofs.com/v1/YIrqSFqjXlS6cA3dBH1N34CSLYoZ5oUQzDqtOY18kaL
> q4napy2NIUcZliGnwlKUQlnbxNbPxLmA0pd3mVL77desKCsG_EsLsbQ/CS80%
> 20schems/41%2520-%2520M%2520Circuit%2520Diagram.bmp
>
> You will see that I highlighted in red two resistors, one set at 100k
> to the HPF and the other set at 47k : do these resistors act as CV
> limiters? And what is more limited, the HPF or the LPF?
>
> Hope these questions are not too hard, thx for any reply
>