Vintage Synth Repair

Hi, it is the last Version, with the DIN Sync.
The Software has been updated also to the last Revision, I think it
was 3.2.


--- In vintagesynthrepair@yahoogroups.com, "gerryrdahl"
<gerryrdahl@...> wrote:
>
> Hi,
> Looking at the supplemental material,
> Does your Source have the updated rom and inputs?
> Your arp an sequencer can run from a sync from
> a drum machine. If the Source things there is 
> a drum machine connected, it may be waiting for the clock
> from it.
> The din socket will say "SYNC IN" below it.
> I would check the associated circuit with this.
> 
> Hope this helps.
> GD
> 
> --- In vintagesynthrepair@yahoogroups.com, "Ambrosia" <s_carter@> 
> wrote:
> >
> > Hi, thank you for the quick answers...  
> > 
> > I did not solder the battery out yet. I measured with the units 
> power
> > turned off. As far as the unit is working well so far, I think, the
> > battery should not be the problem. 
> > The Source is not loosing his patches or something else..
> > 
> > The LFO LED is blinking, and of course you can change the speed of 
> the
> >  LFO. No problem there as far as I can see. 
> > 
> > As far as all IC´s are socketed, this could be a good hint. 
> > Where is the RAM located? which board? I think it has to be the
> > digital board, right? Makes sense to me that the defect could be on
> > this board. Is this the one on the left side inside the unit?
> > 
> > Cheers
> > 
> > 
> > --- In vintagesynthrepair@yahoogroups.com, "martinreuter"
> > <FrauReuter@> wrote:
> > >
> > > 
> > > > The battery is good (3,4 V) 
> > > 
> > > Hi, sorry about the poor question: 3,4 V at work oder did you 
> solder
> > it out?
> > > My Matrix 1000 had a battery with 3,4V, too. But it was not 
> good. I
> > measured it in my Hand 
> > > with a digital Voltmeter - a friend told me that this cannot say
> > something about the batterys 
> > > real Status, i have to measure under work. I changed it and now 
> the
> > Matrix works very fine...
> > > 
> > > cheers
> > > Martin
> > >
> >
>