Emu XL-7 & MP-7 User's Group

just to confirm that your NOT spraying the contact cleaning on / down 
the side of the shaft!!
All this will do is de-greese the encoder and it will feel nasty to 
use after.
Your just spraying the base of the encoder where the electrical 
contacts are. Theres a small opening where you can get it in there, 
near where the 3 legs come out of the part.
As for wiggling the shaft.. the cleaner will spread over the surface 
by itself. No need to wiggle the shaft!
Just by the action of using the encoder normally after will have the 
right effect.(if the cleaning works!)
Cheers
Gonz


--- In xl7@yahoogroups.com, "just john" <pumi4v802@s...> wrote:
> 
> Would it make sense to wiggle the knob shaft side-to-side a bit 
right 
> after squirting, to spread it around?
> 
> (Gee, I don't know why spammers used to think this was a sensible 
> place to post porn spam, do you?)
> 
> 
> --- In xl7@yahoogroups.com, "gonzinigonz" <gonzini@f...> wrote:
> > 
> > you shouldnt mess up if your carefull. Just remember not to use 
to 
> > much, infact the smalleset amount.
> > When you spay it leave it a few minutes before you tun the 
encoder..
> > Cheers
> > Gonz
> > 
> > 
> > --- In xl7@yahoogroups.com, "just john" <pumi4v802@s...> wrote:
> > > 
> > > --- In xl7@yahoogroups.com, "gonzinigonz" <gonzini@f...> wrote:
> > > > 
> > > > Just posted a photo in the 'photos' section, pic 14 the last 
> one on 
> > > > page 2..
> > > 
> > > Thanks!  That's exactly what I was looking for!
> > > 
> > > Now, when I mess it up completely, it'll be MY fault!  (I'm 
very 
> > > posessive that way.)