Not sure which virus you are using but page 120 of the virus c manual states:
"MULTI PROGRAM CHANGE ENABLE
This function controls if the VIRUS receives pro-
gram changes of multi-setups. If enabled, the
VIRUS switches an entire multi-setup by a pro-
gram change. The global MIDI channel has to
be used to receive the program change. Please
note that the multi program change will no
work in the single-multi mode, because, in this
mode, the display is unable to show the
change."
This is a system parameter setting. I don't own a viruse so I may not be able to help much further.
your best bet if you want to use the same multi for a whole pattern in the command station is to put the program change in the Tick 0. I have tried to figure this out myself and followed instructions but couldn't get it to work, can someone who did this and had it work please explain it?
On 6/10/2013 4:30 PM, nikitsanpsix
wrote:
--- In xl7@yahoogroups.com, Susan Subtract wrote:
>
> program change message sent from command station?
>
Yes! but how record it for change multisetup? Im using several channels (presets/tembres).