Each voice board had his own id. This id is set with a strap. So when you swap the board, you didn't swap anything since each board kept his previous ID.
Kris
Le 10 juil. 2012 à 13:12, Terje Winther a écrit :
> The problem is that a board swap should not displace the problem...
> except if you do the mistake to swap the ribbon at the same time.
>
No, no: The ribbon cable stayed in the same position, while I swapped
the boards.
And yes, a board swap should not displace the problem.
So I must probably be looking for something else. I am trying to check
for anything physically, a ground problem, a short somewhere ...
Does the M-12 has any way to recognize which board is where? I would
not think so, because it should be possible to put in a voice board
from another M-12.
Terje Winther
terje.winther@...
http://www.wintherstormer.no/