68300

Jeff,
 
My sincere thanks for your replies.  I felt I was going in the right
direction, but it is always good to hear confirmation from the experts.
 
Although I was hoping to avoid it, I do have the option to cut my data rate
in half (to 500 kHz).  At 1 MHz my loading of the bus would be about 15%,
with 500 kHz we would be about 30% for a maximum.  In the early days, I
found that 250 kHz was a definite problem, and I needed something in the 330
kHz range for decent operation.
 
I do have another questions, though.  If I would end up needing the 1 MHz
data rate and a longer network on a future design, do you have any
suggestions as for how to do this?  I came up with a couple of ideas, but I
do not know how well they would work:
 
1.  Replace the line tranceiver chip with a fiber optic cable network.
 
2.  Make up a repeater module using a microcontroller with 2 CAN bus
controller modules to act as a CAN message receiver / buffer /
re-transmitter unit.  But some of the effective data bandwidth will
obviously be limited by the repeater's processing time.
 
Again, thanks for your help, Jeff.
 
Jim

-----Original Message-----
From: jeffrey.tenney@... [mailto:jeffrey.tenney@...]
Sent: Wednesday, August 28, 2002 7:54 PM
To: 68300@yahoogroups.com
Subject: Re: [68300] 68376: CAN bus rate and length issue



Jim,

Oops, correction here.  Another difference in your choices for TouCAN
settings is the sample mode, once per bit or three times per bit.  I have
no idea why they even put that option into the TouCAN, but my opinion is
that it's useless.  Pick your sample point (as you've picked 80%) and let
the CAN protocol do the rest.

Jeff



Yahoo! Groups Sponsor	

ADVERTISEMENT
 
<http://rd.yahoo.com/M=233351.2287382.3722243.2225243/D=egroupweb/S=17065542
05:HM/A=1212975/R=0/*http://www.gotomypc.com/u/tr/yh/grp/300_mapG/g22lp?Targ
et=mm/g22lp.tmpl> 	

---------------------------------------------------
To unsubscribe from this group, send an email to:
68300-unsubscribe@yahoogroups.com

To learn more about Motorola Microcontrollers, please visit
http://www.motorola.com/mcu <http://www.motorola.com/mcu> 



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
<http://docs.yahoo.com/info/terms/> . 




[Non-text portions of this message have been removed]