AVR-Chat

atmega8


________________________________
 From: "wagnerj@proaxis.com" <wagnerj@proaxis.com>
To: AVR-Chat@yahoogroups.com 
Sent: Monday, 23 January 2012, 20:21
Subject: Re: [AVR-Chat] Re: avr programming
 

  
What chip?

Jim Wagner

> i programed the fuse bits  with following
> ckesl0=1
> cksel1=0
> sksel2=0
> cksel3=1
>
> and then i can not program it because the the program show chip enable
> error 
> my programmer is the parallel and have isp port and have socket for mega8
> with 6000000MHZ crystal
> when i programed it on internal crystal i do not have any problem but in
> external i have problem  and the programmer can not erase chip or
> programmed it
>
>
> ________________________________
>  From: muhammad SHABBIR <moghul40@yahoo.com>
> To: AVR-Chat@yahoogroups.com
> Sent: Monday, 23 January 2012, 7:06
> Subject: [AVR-Chat] Re: avr programming
>
>
> Â 
> Dear sania
> i have own build isp programmer and using since last 6 years with tiny2313
> its good working. also now using with atmega 48 nice working. and now in
> nov 2011 i bought G540. but not checked on avr som work on eprom with g540
> its good.. now tell me in detail. where is the problem. on  tiny 2313 i
> worked with avr studio and little ave assembler.
> shabbir
>
> --- In AVR-Chat@yahoogroups.com, sania safdar <see_wide_sea@...> wrote:
>>
>> g540 and ISP
>>
>>  
>> Best Regards
>> Sania Safdar
>>
>>
>>
>>
>> ________________________________
>>  From: Zack Widup <w9sz.zack@...>
>> To: AVR-Chat@yahoogroups.com
>> Sent: Saturday, January 21, 2012 8:47 PM
>> Subject: Re: [AVR-Chat] avr programming
>>
>>
>>  
>> What programmer are you using?
>>
>> Zack
>>
>> On 1/9/12, shirin ghanbari <shivarin12@...> wrote:
>> >
>> >
>> >
>> > I program the fuse bits of the avr mega under 1.5MHZ external crystal
>> and
>> > then i can not program it it . chip enable error
>> > please help me what can i do?
>> >
>> > [Non-text portions of this message have been removed]
>> >
>> >
>>
>>
>>
>> [Non-text portions of this message have been removed]
>>
>
>
>
>
> [Non-text portions of this message have been removed]
>
>


 

[Non-text portions of this message have been removed]