AVR-Chat

Hi Alex
I had the same problems my self
I built the ISP board in order to load the software to the prototype board that I built and couldn't do it right until I used the AVRDUDE software 
Try it ......It is simple and works.

My suggestion for you is not to spend a lot of time as I did by tiring to build the ISP board...
If you want my opinion 
Try to use the STK200 Dongle (if you have one like this) 
And if you don't have one like this then make your self a favor and buy one .
It will speed your work and will take this out of your mind for the rest of your prototypes

-----Original Message-----
From: Alex Shepherd [mailto:maillists@ajsystems.co.nz] 
Sent: Sunday, October 31, 2004 3:18 AM
To: AVR-Chat@yahoogroups.com
Subject: RE: [AVR-Chat] Newby setup help



> The software is Mandrake Linux and PonyProg.  I've
> tried both the serial and parallel dongles and can't
> seem to get them to communicate with the prototyping
> board.
> 
> Any pointers?

You could try the AvrDude programming software. I think it compiles under Linux.

http://savannah.nongnu.org/projects/avrdude/

Alex





 
Yahoo! Groups Links



 

*****************************************************************************************************
***************************************

This e-mail message has been sent by BAE Systems Rokar International Ltd.. It is 
designated solely for the intended recipients and may contain privileged or confidential 
information. If you are not the intended recipient you are hereby notified that any use, 
duplication or distribution of this information is strictly prohibited. You are requested to 
delete this Email and any attachments from your computer and kindly notify the sender 
immediately.

*****************************************************************************************************