I'm working on a project using an AT-Tiny26. It has been working fine. But now the Tiny26 seems to not want to run any more. It can be programmed and read back fine, both in SPI mode and on a parallel programmer. All the fuse bits are set correctly to the default 1MHz settings. We have written a very simple program which just wiggles a pin up and down. But it just won't run. This is the second time this has happened - the first time, we replaced the Tiny26 and all was OK again. Anyone seen this before? It almost looks like some setting is wrong. -- Tim Mitchell tim@sabretechnology.co.uk http://www.sabretechnology.co.uk
Message
AT-Tiny26 suddenly won't run
2006-03-10 by Tim Mitchell