AVR-Chat

At 09:35 AM 22/01/2008, you wrote:
>At that point, it told me that the debugwire wasn't enabled (correct)
>and I told it to use ISP mode to enable debug wire.
>That was the last I was able to talk to the chip.

I guess you are being a good boy and cycle the target power
as required just after any changes?

>STK-500 with reset jumper removed.

So basically there is nothing but the internal weak reset pin
pullup and the stray capacitance of the STK500. I would still
try a 10K pull up. All my boards use a 4K7 pullup.

Brick wall coming up......

Regards

John Samperi

********************************************************
Ampertronics Pty. Ltd.
11 Brokenwood Place Baulkham Hills, NSW 2153 AUSTRALIA
Tel. (02) 9674-6495       Fax (02) 9674-8745
Email: john@ampertronics.com.au
Website  http://www.ampertronics.com.au
*Electronic Design * Custom Products * Contract Assembly
********************************************************

> I guess you are being a good boy and cycle the target power
> as required just after any changes?

Yup

>
> Brick wall coming up......

Yeah.. @#$!$%#^