AVR-Chat

I just went through this a few weeks ago, and here I am again. :-P
Where is the list of which device goes in which socket on the STK-500?

I would have thought it nice to have a mention in the data sheet for 
the device, or a list in the STK-500 docs, but what I remember is that 
it's a separate document somewhere that's relatively obvious once you 
already know where it is. 

Anybody remember?  Kathy, as I remember you helped me find it last 
time.

David VanHorn wrote:
> 
> Ok, for what it's worth, it IS in the STK-500 user's guide under ISP
> Programming.
> What I was looking for was "socket selection" which is right above that,
> and tells you essentially nothing about selecting which socket to use,
> almost as if it should have been a link to the part in the ISP
> programming section that does.
>  
> Anyway, in case someone else needs to find out how to pick which socket
> for which chip on the STK-500

Recently, I had to use my STK-500 to program some tiny series chips (11,
13 & 45) and have found the user's guide one confusing mess.  Sure would
be nice if someone could come up with a good chart which would show the
device, the socket, and exactly the jumper configuration.  Anyone done
this yet?

Don

> Recently, I had to use my STK-500 to program some tiny series chips 
(11,
> 13 & 45) and have found the user's guide one confusing mess.  Sure 
would
> be nice if someone could come up with a good chart which would show 
the
> device, the socket, and exactly the jumper configuration.  Anyone 
done
> this yet?

Nothing beyond the table that you finally find, one click below where 
you'd think it would be.