Boss VF-1 Effect Processor

Hi David,
I also use a fbc with my vf-1.

It is seems so complex at the beginning, but it is not
!
To use a pedal for expression,
-on vf-1, go to the master section of the patch in
question.
-select the related assign number (assign 1, 2 and
etc)
-select the target (wah manual, foot volume etc)
-target min and max should be 0 and 100
-do not select source type as exp pedal, you should
select the midi channel number here, like you said
mid-7. This is the main trick in here
-source mode should be normal
-source min and max should be 0 and 127

Now you should configure the fcb,
-you will either use 8th or 9th button-
-for related patch, you will select the related exp
pedal number by pushing it for 3 seconds in
configuration mode
-after the light comes, push once for editing the
parameters, this time the light blinks
-press "up" button once
-when number light blinks at the panel, you should
enter the midi channel number (same number that you
entered to vf-1)
-press "up" button again
-then "value" light blinks at panel
- you should enter the source min and max
consecutively same as you entered to vf-1
-after each section press "up" for saving parameters
-at the end press down for 3 secnds.


This is how I configure it out.

Regards...

Cagan




--- spangler1941 <spangler@...> wrote:

> I am trying to use a FCB1010 with a Boss VF-1 simply
> to switch banks,
> patches and control volume. So far it is baffling to
> me. Mainly need
> help how to configure the VF-1 to recognize an
> expression pedal on the
> FCB1010. I was doing fine with a Digitech Control 8
> and set the VF-1
> to MIDI 7 for the expression pedal in each patch.
> But I like the 10
> patch switches of the FCB1010 much better. Just need
> to get one of the
> expression pedals going.
> 
> Thanks, David Spangler in Texas
> 
> 
> 
> 
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com