Message
Re: [Evolver] Re: Evolver update from OS 1.0?
2003-09-29 by Stefan Weber
tell?! ...when Dave's instructions specifically said, "Thou shalt
not remove the power source from thy Evolver during the sacred
procedure"?
You have some seriously large copper/zinc alloy spherical objects!
Kidding aside, I AM surprised that your Evolver still works. I can't
imagine why the procedure didn't work, unless a) you just needed to
wait longer, or b) you still need more and/or larger output buffers.
You DID adjust the OUTPUT buffers, and not the INPUT buffers, right?
I actually had the same problem the first time I tried to upgrade to
v1.4, but it was because I hadn't adjusted the output buffers. I
thought my Evolver PIC/DSP chips were hosed, but I simply performed
the procedure again (*without* powering off/on) after adjusting the
buffers, and everything went fine.
You may want to try more and/or larger buffers, but I'd probably
email Dave on this one. Best of luck!
Ski
www.ex5tech.com
EX5Tech Evolver forum:
http://www.ex5tech.com/ex5ubb_cgi/ultimatebb.cgi?ubb=forum&f=23
--- In DSI_Evolver@yahoogroups.com, Robert Shanks
wrote:
> Hi all -
>
> I seem to be having problems with updating the Evolver OS. I have
OS 1.0
> for the PIC and 1.0 for the DSP. Evolver #007. I'm using MidiOx
with the
> 1024/128 output buffers as Ski suggested. The Evolver counts down
>from 31
> to 0, but then just shows 99 and freezes up until you pull the
power plug.
> Everything comes back up fine when you repower, but I sure would
like to
> try out that new OS and bank o' patches. (Are the new patches from
> Evolutionaries? If so, I've got that.)
>
> Anyway... I thought I'd ask here before I email Dave.
>
> Thanks - Robert
To unsubscribe from this group, send an email to:
DSI_Evolver-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.