Yamaha DTXpress/DTXplorer/DTXtreme

Thank you very much for the quick help.
I will try your suggestions and will consult the manual too.
Does the DTXpress has any Reset button or Load Factory Defaults as 
contigency plan?

thanks
Antonis

--- In DTXpress@yahoogroups.com, "emf" <liberatusvirus@y...> wrote:
> 
> --- In DTXpress@yahoogroups.com, "Antonis" <antonis21@y...> wrote:
> > 
> > 
> > Hi to all,
> > 
> >  I've notice that when I hit the hi-hat or the tom3 near to rack 
> > connection point the hi-hat produce sound from snare and tom3 
voice 
> > from ride. I tried different trigger type but the problem was 
> worst. 
> > STD Med is what I always used.
> > Why is that happening?
> > To help you understand the exact area that the wrong voice 
produces 
> > see the following pic
> 
> Antonis,
> 
> Welcome to the club. Such crosstalk is a common occurrence, and 
> Yamaha addresses its remedy in the manual, which you should 
consult, 
> poorly organized and written as it is. The hits on your hi hat and 
> tom3 are creating vibrations along the rack that cause other pads 
to 
> trigger sympathetically. By adjusting the rejection and specific 
> rejection numbers, as well as those for gain and minimum velocity, 
in 
> the Trigger Edit Mode for the reactive pads, you should be able to 
> mitigate the problem. But be sure to adjust these parameters only 
to 
> the bare extent that they eliminate the crosstalk; don't just 
settle 
> on a high or low number. The cure can be worse than the disease: 
Bad 
> programming can make pads refuse to fire under ordinary 
conditions. 
> So look in the index under the terms that I've mentioned and get 
back 
> to us if you need further help deciphering what they mean and how 
> they operate.
> 
> Ed